VisionStat Plus MA-BCKS-7.0 Bedienungsanleitung PDF herunterladen (Seite 18)

Mobile Awareness

Alternate Sensor Mounting Locations

The system is designed to be installed with all 4 (four)

Sensors aligned across the rear of the vehicle, preferably

at a height ranging from 16” to 32” from the ground.

When the Sensors are installed in a different layout (for

example to detect a building overhang as shown on the

right), please consider the following:

 Each Sensor detects objects in a circular area

approximately 20” in diameter. The Sensor field of

coverage can be seen below in Figure 35.

 When the Sensors are placed on two different levels

(per the example to the right) install S1 and S4 on the

top and S2 and S3 on the bottom of the vehicle.

 It is recommended that the face of all Sensors should

be on the same plane to maximize the accuracy of the

system.

Sensors can also be mounted across the front of the vehicle to detect building

overhangs or to detect objects out of view.

NOTE: SenseStat is a tool to help the driver. The driver should always know what

is in front of or behind them and physically check the area themselves.

CAUTION: Using less than 4 (four) Sensors across the width of a bumper will

create limited coverage resulting in blind zones! It is strongly suggested that

these blind zones are mapped out to educate the driver regarding the system

limitations. See Figure 37.

Fig 34

Fig 35: Sensor Coverage. All Four Sensors (left) and Single Sensor (right)

Fig 36: Alternate Sensor Mounting Locations

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Keine Kommentare

VisionStat Plus MA-BCKS-7.0 Bedienungsanleitung Seite 18