VisionStat Plus MA-BCKS-7.0 Bedienungsanleitung PDF herunterladen (Seite 9)

VisionStat Plus Video Monitoring and Obstacle Detection Sensor System

The standard Camera issued with the system is the 18IR

Camera which has a 120 degree viewing angle and is

rated IP68. This Camera comes equipped with 18 infrared

LEDs to provide night vision up to 12 meters. It is

mounted on a “U-Bracket” which allows the user to angle

the Camera up or down.

The Side Camera is typically featured in triple Camera

systems. This Camera comes equipped with 9 infrared

LEDs to provide night vision up to 8 meters. The

mounting bracket and protective cover is included with the

Camera.

For other Camera options and information, please visit

www.mobileawareness.com.

About the Cameras

Fig 5: 18IR Camera

Fig 6: Side Camera

The Electronic Control Unit (ECU) is an intelligent microcontroller system with four (4)

individual Sensor inputs, all contained in a waterproof enclosure. There are four (4)

integrated cables labeled S1, S2, S3 and S4, which will connect to the four (4) each

Sensor Units. There are two mounting holes for securing the ECU, either inside or out-

side, at the rear of the vehicle. Since the ECU is watertight, it can be installed under-

neath the vehicle to facilitate the installation.

NOTE: Depending on the version, the ECU may have four (4) sensor cables that

are 12 inches long. Use the included 5M Sensor Extension Cable (P/N: MA-ODSS

-M17-SCE) to connect the sensors. The ECU may also have the cable built into

the ECU, where cables S1 & S4 = 9 2/3 ft (2.95M) long and cables S2 & S3 = 8 ft

(2.45M) long.

Fig 7: VisionStat Plus ECU

About the ECU:

About the Sensors

The Sensor Unit consists of a waterproof ultrasonic transducer designed for high accu-

racy measurement. The standard mount consists of a rubber sleeve, set in a metal

mounting bracket for under the bumper mount. Eight (8) holes are drilled to attach the

four (4) each mounts with the enclosed stainless steel mounting screws. The Sensors

are labeled S1, S2, S3 & S4 to match the waterproof threaded connectors which have

an O-ring seal. Sensors can also be mounted directly in the bumper using the rubber

sleeve or the optional SE Sensor Mount hardware.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Keine Kommentare

VisionStat Plus MA-BCKS-7.0 Bedienungsanleitung Seite 9